Availability: In Stock
1 ON THE SIDE, 1 ON THE BOTTOM
We often recommend attaching 1 end of your Peak Design strap to your camera's side strap lug (opposite the grip) and the other end to the bottom. These 2 connection points let the camera hang with the lens facing down for greater comfort and stability, especially with longer primes and zooms.
Anchor Mount is the most low-profile, unobtrusive connection point available for Peak Design Anchors and standard camera straps.
WORKS WITH ALL PD STRAPS
Attach PD Anchors to increase your carry options with any of our straps. Compatible with all versions of our Anchors and straps.
WORKS WITH OEM STRAPS
Attach any standard camera neck strap or wrist strap. Works with strap ends up to 11mm wide.
Ultra-secure 4mm hex drive with anti-twist pad.
FITS ANY CAMERA
Screws into any standard 1/4""-20 tripod socket.
Rugged, weatherproof machined/anodized aluminum construction.
Note: Anchor Mount is not compatible with tripods or Capture system. If you frequently use a tripod or Capture, check out our Standard Plate.
What is in the box
- 1 x Anchor Mount
- 1 x 4mm hex key
Wrist Loop Size
Diameter when open: 9.7 cm (3.82 in), but easily fits hands 5+ inches wide diameter when cinched: 4.5 cm (1.75 in)
19 mm (0.75 in)
Anodized aluminum plate with hard rubber anti-twist pad, turned/machined stainless steel hex-drive screw
Unpackaged: 18 g (.71 oz)
Packaged: 36 g (1.3 oz)
Length: 30 mm (1.2 in)
Width: 20 mm (.79 in)
Height (protrusion from camera): 5 mm (.20 in)
STRAP LOOP SIZE
Fits straps up to 13mm (.51 in) wide
Can withstand well over 200 lbs (90 kg), making Anchor Mount safe for use with the largest of professional cameras.
Guaranteed for life.
Enter your information below to be notified when Anchor Mount is back in stock. See our stock article for additional information.
Thank you for subscribing!!!